2000-2004 FORD SUPER DUTY Installation Instructions – F450/550 1. Remove front bumper saving the fasteners for re-installation. 2. Remove clamp holding power steering cooler lines to radiator support. 3. Remove and relocate power steering cooler toward the drivers’ side approximately 6” and re-install with self-tapping screws. (Request drawing to show cooler location.) 4. Install plastic split tubing or a similar insulating/protection type material onto lower portion of each cooler line and secure with wire ties. 5. Securely fasten cooler lines utilizing a 1½” insulated frame hose support clamp to the side radiator support as shown in illustration (pg. 14) with a self tapping screw. 6. Remove tow hook fasteners and install left and right tow hook post brackets “A” utilizing the original fasteners and tow hooks. Due to possible casting irregularities of front spring hanger, it may be necessary to radius the corners of bracket “A” to insure complete base surface contact within the spring hanger pocket. (Leave bracket fasteners slightly loose for further assembly and final alignment check.)