Burien Toyota 5SFE Turbo Installation Instructions Disclaimer: This project and related modifications are the responsibility of the vehicle owner. Alterations may be required to the engine to allow the installation of a turbo charger. Neither Toyota Motor Sales, U.S.A., Inc. nor Burien Toyota can be held responsible for changes required to install this kit. Although, rest assured we will provide support before, during and after the installation and make every attempt to work with you to make your installation a successful one. Be sure to read and understand these entire instructions before starting your installation to be sure you have all parts and tools needed to complete the work. Also inspect your engine before installing this kit to be aware of leaks, vacuum or fluid, loose parts or damaged parts. Be sure your engine is running well before the installation.... The following parts are not required, but you may want to have on hand: Fresh Toyota engine coolant New engine oil (preferably synthetic) and new Toyota oil filter New parts to perform a tune-up (spark plugs, distributor cap & rotor). If you do replace your plugs, you may want to use a colder plug to reduce the chance of detonation. New Ignition wires, if your current wires are old New Toyota fuel filter (since you’re replacing the expensive injectors) Shorter oil filter union from Toyota (See step #11) Tie-wraps to secure vacuum lines (See step #27) Shielded audio cable (See step #26.b) For automatic transmissions, consider replacing the transmission fluid with a good synthetic brand and installing an ATF cooler.