MAZDA PROTEGE REAR KIT PART INSTALLATION MANUAL

ID# : 3459
Under Category : Automotive Guide Mazda
Source: www.easystreetair.com

Cached Content

. responsible for all repair charges. . air management system instruction manual for . p.s.i. Check your vehicle owners manual and do not exceed the maximum .

File Summary

IV. Installing the Air Line NOTE: If you will be installing an air management system with this kit, follow the instructions on the next page. If you will not beinstalling an air management system at this time, continue tosection V. 1. Refer to the air management system instruction manual for directions on how to install your particular system. 2. If possible at this time, secure the air lines under the vehicle AWAY FROM HEAT SOURCES. NOTE: It may be helpful to install the strut before securing the air lines. Refer to section V for strut installation instructions. NOTE: You may need to drill a hole in the inner fenderwell. If so, follow steps 3-5 below. If no drilling is needed, proceed to sectionV after the air management system is installed. 3. If a hole needs to be drilled to secure your air line, hold the strut up to the vehicle where it will be in place and make a mark onthe inner fenderwell where the air fitting and air hose will passthrough it. NOTE: The air fitting should point toward the rear of the vehicle. Correct air fitting installation is shown in the figure below.

             Help others by telling us that this link is not pdf file.